Hope some on can help my DJM850 lost a channel during a set last night. I was mixing externally through Traktor using 2 CDJ900. The CDJ was playing fine but the sound via my channel just disappeared. I hadn't switched the sources or killed any of the Eqs it just went dead.
I c an reroute the input to a different channel for the time being but I cannot afford to have this happen again.
Really disappointed with what happened as my set was going really well to the point luckily I managed to put on a premixed set to see me to the end of my slot.
Anyone else experienced this?
Post ist für Kommentare geschlossen.
@Crem > So this only happened on one channel? You were able to transfer to another channel and continue with your set, right?
Does the issue continue to occur or was it a one time only occurrence?
Yes only on one channel but couldn't switch on the fly as I am running the tsi file for my ddj sp1 which really lags when you open traktors preferences . I did switch to an mix on an iPhone fed straight into a spare channel to get me out of the problem
It had happened earlier in the evening during set up but only after the mixer had been on for an hour or so. I wonder if this is an issue with a dry solder joint that is opening up when the heat builds up
Forgot to say I just powered it down first time and left it stood for a while, checked connections and the issue went away until mid set
@Crem > Yeah, it sounds suspiciously like a hardware issue / potential defect. I'd advise you to contact technical support using the links on the right >>