[SOLVED] CDJ-400: Rotary Dial Mapping Error

Hi..

I am using Traktor 2.5.1 with XP in external mixing mode with a pair of CDJ-400s via HID. My CDJs have firmware version 1.3.3. Generally everything works except for the mapping of the of the rotary dial. See below for a description:

Turning the knob on either deck A or B works as expected: it changes the selected track in the Traktor library section.
Pressing the knob on deck A or B also loads a track in to the corresponding deck, as expected.
Problem: Pressing the knob on either deck A or B also triggers cue on both decks!! This means that I can't load a track into one deck without stopping the other.

Please help.

Chris

DJ Christopher 8. September 2012 12:42

Post ist für Kommentare geschlossen.

Datum Stimmen

4 Kommentare

@Christopher > All firmware, drivers and software updated to the latest available versions, correct?

Did you run the Setup Wizard when you connected the CDJs to the software?

Gavin 11. Oktober 2012 18:06 0 Stimmen

Sounds to me like you have overlapping MIDI commands. Make sure each deck is assigned to a different MIDI channel then verify the commands within the Controller Mapping (within Traktor's Settings) and check that the MIDI instruction for CUE is not the same as the rotary selection.

Pulse 24. April 2013 23:34 0 Stimmen

All is working now, thanks.

DJ Christopher 24. April 2013 23:38 0 Stimmen

@DJ Christopher > Thanks for reporting back and letting us know.

Gavin 25. April 2013 11:19 0 Stimmen