WeGo3k problems jog wheel and output

Hi,

I have connected the unit to a Macbook air and using Djay software,

Upon playing a track, I can cue normally in 'vinyl' mode by moving the platter back and forth.

After about 30 seconds, I am unable to scratch the track. As soon as I touch the platter, the track sounds distorted. This is happening on both channels.

Also, in a separate issue, I am going to be connecting my WeGo3 to a DJM 300 which is then plugged into a bar mixer (I use the mic and the acoustics of the room need more treble)

I tried this previously, but could not hear the channels on the WeGo via the headphones. I could only hear it via channel 1 on the DJM 3000

I'm sure it's a case of changing the setting on the Djay software but I don't know what.

Any advice much appreciated.

AB 25. Dezember 2015 14:30

Post ist für Kommentare geschlossen.

Datum Stimmen

3 Kommentare

How do you have the audio config in DjJay?

Jay 26. Dezember 2015 21:09 0 Stimmen

How do I change the settings in Djay?

AB 27. Dezember 2015 15:33 0 Stimmen

It should automatically configure itself for the controller when it's detected. The distortion could be due to the audio buffer not being high enough, try adjusting that a bit.

As for the DJM-3000, if you've connected the output of the WeGO to the DJM, you should keep your headphones connected to the WeGO so you can independently cue the channels.

Pulse 27. Dezember 2015 23:15 0 Stimmen