Problem Firmware (1.31) DJM900nxs

Dear friends, I updated the firmware DJM900NXS mixer (1:31), made the entire procedure until the success message, ran only twice. Now the mixer no longer starts when you connect it blinks three times the LFO FORM button and the mixer will not start. What happens?

Dide Gemignani 15. September 2015 22:01

Offizieller Kommentar

@Dide > Sorry to say but that is a hardware failure indicator - you'll need to contact Pioneer technical support for service or repair information.

Pulse 17. September 2015 17:56

Post ist für Kommentare geschlossen.

Datum Stimmen

6 Kommentare

@Dide > Are you able to boot the mixer into firmware update mode?

Pulse 16. September 2015 00:57 0 Stimmen

Unfortunately not! I'll have to change the motherboard?

Dide Gemignani 16. September 2015 01:06 0 Stimmen

I can not even begin to do Mixer update. He stops at startup and flashes 3 times the LFO FORM, not out of it. What should I do? Help me!!

Dide Gemignani 16. September 2015 02:47 0 Stimmen

@Dide > Does the display show anything at all or is it only the LFO FORM LED that blinks?

Is it blinking in a pattern of 3 blinks then off, then repeat?

Pulse 16. September 2015 17:30 0 Stimmen

Hello! Flashes the LFO FORM three times off for 1 second and will flash again three times. It is also lit X-pad and the channels 1, 2, 3 and 4, MIC A, B and MST, parameter 0 is 0 and the display. It behaves as if the mixer had caught. Nothing in mixer or more lights work. Is it no problem at source of energy?

Dide Gemignani 17. September 2015 02:14 0 Stimmen