XP2 with two CDJ800s and an XZ (and rekordbox)

Yes, you can use the XP2 with two CDJ-800s and the XZ for DVS control with Rekordbox, but keep in mind:

• The CDJ-800s don’t have full Rekordbox performance features like newer models, so you’ll mainly get basic playback and cue control.

• The XP2 allows you to use timecode vinyl or CDs with DVS unlock, so you can control your digital tracks via the turntables.

• The XZ mixer is fully compatible with Rekordbox DVS and will handle the timecode signals properly.

It should work fine for basic DVS, but some advanced CDJ features won’t be available on the 800s.
deltarune

You record your performance using Serato while the bug is happening, does the recorded output also have out-of-sync FX?
all australian menus.

Hi Geometry Vibes!

It can work, but only at basic DVS level: play, pause, scratch via timecode. XDJ-XZ can still work normally as a USB/HID player, but if you route via XP2 it is mainly for DVS.

You'll need to burn or obtain rekordbox timecode CDs and put them into your CDJ-800s. When you "play" the timecode CD, the CDJ-800 sends the dailypay timecode signal to the XDJ-XZ, which then sends it to your computer. The rekordbox software interprets this signal to control the playback, scratching, and cueing of your digital tracks.

If you’re planning to use an XP2 with two CDJ-800s and an XZ for DVS with Rekordbox, it should work, but there are a few things to keep in mind. The XP2 will act as your audio interface, letting the XZ send timecode signals to Rekordbox so you can control digital tracks like vinyl. The CDJ-800s can still handle playback, jog control, and navigation, though some advanced features like slip mode or certain effects may be limited depending on compatibility.

Overall, you’ll get full DVS control through the XZ with more basic control on the CDJs, making it a solid setup for timecode mixing. It’s a bit like using a Magis TV APK—once you’ve got the right setup, everything runs smoothly even if not every feature is fully supported.

If you’re planning to use an XP2 with two CDJ-800s and an XZ for DVS with Rekordbox, it should work, but there are a few things to keep in mind. The XP2 acts as your audio interface, allowing the XZ to send timecode signals to Rekordbox so you can control digital tracks like vinyl. The CDJ-800s will handle playback, jog control, and navigation, though some advanced features may be limited depending on compatibility.

Overall, you’ll get full DVS functionality through the XZ with more basic control on the CDJs, making it a practical setup. It’s kind of like figuring out a Telenor quiz today once everything lines up, it all makes sense 😄

You'll need to burn or obtain rekordbox timecode CDs and put them into your CDJ-800s. When you "play" the timecode CD, the CDJ-800 sends the chatgpt apk timecode signal to the XDJ-XZ, which then sends it to your computer. The rekordbox software interprets this signal to control the playback, scratching, and cueing of your digital tracks.

This setup should work fine with the XZ as the main unit and the CDJ-800s running in HID or MIDI depending on how you route everything through rekordbox and DVS. The XP2 would mainly give you extra control over performance features, but the CDJ-800s themselves won’t fully unlock modern rekordbox features since they’re an older generation, so their functionality will be a bit limited compared to newer players.

It’s a good idea to test the mapping and DVS response before investing further, especially to see how stable everything feels in real use. Also, understanding how different systems interact is similar to how structured learning helps in Physics Fundamentals, where small system changes can significantly affect overall performance and output.

Hope this helps you decide