Is it not possible to change the preview player volume in rekordbox?
It's way too loud and I keep have to adjusting the volume between previewing the track and cueing the other deck.
They both need to be the same.
Please sign in to leave a comment.
That doesn't show in my rekordbox and hasn't since I can remember.
Ah yes, you're using the 900NXS2 linked... was that not controlled through the master level at top right? I can't recall.
No, that has no effect.
The only way to change it is with the PHONES LEVEL knob,
but it's so much louder than the CUE track.
In order for the preview and CUE track be the same, or similar,
my TRIM has to be at 12 o'clock which is no good - I need to have my TRIM at 10 o'clock
and my MASTER at 2 o'clock to avoid the red levels.
Hey Shaun, after revisiting this, here's what I've found...
With a track paying over the link to a CDJ, my channel trim set to around the 9:30 position, the master around 2:45, I had both the channel and master peaking at 0dB.
I then loaded the same track to the mixer within rekordbox (same as clicking the waveform to preview), and the volume to the headphones with the mono-split enabled and the mix at centre was even for both.
While there is no independent control for the output volume within rekordbox for the preview link, I don't believe it's necessary and any adjustments needed due to increases on the channel gain on the mixer can be compensated for by adjusting the headphone mix knob.