Issues with Behriner CMD LC-1 knobs and Rekordbox

Hi! I'm trying to make a midi mapping of the Behringer CMD LC-1 controller I've recently bought. My problem is that when I try to configure the infinite knobs with the "learn" function, I can't make it work correctly. When I turn the knobs the indicator stays at 90º and makes an almost imperceptible movement. I want to control my FX level depth with them.

How can I fix this?

Thanks a lot.

Augusto FP May 19, 2021 16:11 Answered

Official comment

It could be the MIDI values transmitted are not in the same scope as expected; for example, it could be a relative vs. absolute, or it might be sending a 14bit signal. You may want to check the documentation for your controller.

Pulse May 19, 2021 22:02

Post is closed for comments.

Date Votes

3 comments

Hi! The Behringer manual offers very little information and It didn't provide me any solutions. Regarding the midi specs, this is the only information available:

https://usermanual.wiki/Behringer/BehringerCmdLc1MidiMap751886.193085656/view

When I use the "learn" function with the infinite knobs, the midi input is recognized as B010, B011, B012, etc (instead of CC016, CC017 as explained in the manual... which also exceeds the maximum amount of 4 digits in Rekordbox). When I open MIDI-OX it also recognized the knobs as B010, B011, etc.

Can you give me more information about possibles fixes?

Thanks!

Augusto FP May 19, 2021 22:16 0 votes

CC is just "control change" and the B010 is just the hex address for the signal... but that doesn't say what kind of signal it is.

Pulse May 19, 2021 22:25 0 votes