[SOLVED] New firmware 1.05 causing platter sensitivity problems

I purchased my 1st DDJ SX in December and immediately fell in love with it even though I'm a turntable (1200's) purist. While learning the unit I set my sensitivity as high as it could go (turned up to the right). Everything worked fine and I fell in love with the SX because I could closely emulate scratching on a actual vinyl turntable. Last week I decided to finally upgrade the FIRMWARE to fix the crappy microphone out distortion problem. After upgrading the firmware to 1.05 my platter/decks immediately started stopping sporadically by themselves with the sensitivity setting to HIGH (Right). If I waved my entire hand over each deck without touching it the sensor would stop responding thus stopping the song...... I figured my unit was defective so I immediately purchased a second SX in preparation to send out the default 1st SX so I had a quality backup unit. After testing this NEW SX (which is already using firmware 1.05) I found out I HAVE THE SAME CRAPPY SENSITIVITY PROBLEM!!!!! $2000 dollars in the hole at this point and I'm close to just saying BUMP this SX and going back back to my trustworthy 1200's. PIONEER PLEASE GIVE US THE OPPORTUNITY TO REVERT BACK TO THE ORIGINAL FIRMWARE. I don't care about the crappy mic out. PLEASE!!!! Moderators i beg you to get back to me ASAP or I'll be returning/Selling both of these. Thank you.