DDJ-SR only turn on in Update Mode

Hello,

I have a Pioneer DDJ-SR.
Was connecting and using it normally.
But it was in firmware version 1.02 and I wanted to do the update to the latest firmware which is 1:07.

I turned her on in update mode (Shift + Sync) and the lights of the meters (coloured lights between the volume faders) began to flash because it was getting in update mode.
It connected to my computer and did the update.

But after that, whenever I try to connect it, regardless of the way, it always turn on as if it its in update mode. Whenever I turn it on, the small lights of the central meters between the faders blink and it does not connect normally as before.

What has happened or what is happening? I use a Windows 7 PC.

Thank You

Pedro Maurício Nader 2 de septiembre de 2015 00:11 Respondida

Comentario oficial

It could be the update didn't take properly - try running it again and see what happens.

Pulse 2 de septiembre de 2015 00:14

La publicación no admite más comentarios.

Fecha Votos

10 comentarios

Already tried, and didn´t worked.
=/

Pedro Maurício Nader 2 de septiembre de 2015 00:18 0 votos

Did you try forcing it into update mode (by holding the appropriate buttons) when powering on the unit, then updating?

Pulse 2 de septiembre de 2015 00:20 1 voto

Yes i did it. But the problem is that, after that, the Controller always turn on into Update Mode.
Even if i just switch it on normally (just pressing the ON/OFF buttuon) it stills turn on in the Update Mode (the middle metters coloured lights turning on and off).

Pedro Maurício Nader 2 de septiembre de 2015 00:36 0 votos

And did the update complete successfully each time it was run?

Pulse 2 de septiembre de 2015 00:37 0 votos

My PC recognizes it, as i was connecting it to perform the update

Pedro Maurício Nader 2 de septiembre de 2015 00:38 0 votos

Yes, i did it completely 3 times.

Pedro Maurício Nader 2 de septiembre de 2015 00:38 0 votos

I've opened a ticket with the engineers to see what they say. Thanks for your patience!

Pulse 2 de septiembre de 2015 00:41 1 voto

I tried it again now and it worked!

Thank you for you attention and pacience. Lokks like that, for some reason, the update wasn´t being sucessful. Now it worked.

Sorry about my bad english, and thank you again.

Pedro Maurício Nader 2 de septiembre de 2015 00:44 0 votos

Ah, so it did complete and the SR restarts normally now?

Pulse 2 de septiembre de 2015 00:46 0 votos