Totally weird - will pass this to the engineers.
[CLOSED] RMX1000 FX continue during set, need a restart...
Well the more comfy I'm getting with the RMX1000 the more FX I'm adding- should note in Ibiza a lot of DJs have been abusing the FX during their sets as I noticed there the other week.
So the new problem with firmware 1.3.1 is if I've used a combination of Cut/Add and HPF Echo and roll/pitch then kill all FX after a while there's still a little bit of echo coming out of the RMX- checked all the knobs and everything is off- but the echo continues. turned the send/receive off on the mixer and the echo is gone... re-engage the on/off and the echo comes back. Again there is nothing activated on the RMX but it continues to churn out a little echo.
The only solution was to turn the send/receive off and re-start the RMX by turning it off for about 5 seconds then re-starting it... waiting about 7 seconds before re-engaging the send/receive on/off from the mixer end.
Had to repeat the reboot about 4 times in a 3 hour set.
Anyone else have this problem?
Cette publication n’accepte pas de commentaire.
@maDJam > I'm sorry to open up an old thread but I believe you have been able to resolve this issue...? If so, can you explain how?
Hey Gavin! Well it has happened a few times over the last few months... all I do is switch off the send/return then restart the RMX- it usually happens if I'm using all 3 FX (add/cut, roll + pitch & HPF Filter) then the echo sometimes just comes in randomly... this has continued even after the recent updates...
A quick restart is cool- doesn't hurt anyone ;)