Have a feature request or suggestion? Post your idea here!

Publication

2 abonnés S’abonner
0
Avatar

DJM-800 digital output for recording

I'd like to record using a digital audio interface with coaxial S/PDIF interface connected to the DJM-800.

Is it possible to route the pre-master-level-knob signal to the digital output (ie. always like master fader at max 0dB)?

In that way I could record using the full dynamic range of 16-bit audio and still use the master knob to control the volume level being sent to the amps -- if not, I'll have to build myself an additional master volume controller for the amp levels and always leave the master level knob at max on the mixer...

I'm versed with electronics and firmware hacking, so non-conventional answers are welcome too :)

Daniel Golle

Vous devez vous connecter pour laisser un commentaire.

1 commentaire

0
Avatar

The SPDIF is sourced after the digital domain master volume control.  There is the analog master attenuator setting on the back of the mixer, but it only adjusts in crude increments.  There's no way to source the SPDIF from the REC feed, for instance.

The master out volume knob, by the way, is unity at like 2:30ish o'clock if you're running your channel faders' unity as max.  I believe Pioneer originally meant people to run the faders as unity at 7 out of 10 with the master volume unity at max, but most don't do that.

Generally, I think it's a bad idea to give boost over unity on the master volume, or to have the guest DJs access to boosting the system volume.  I'd just suggest you stick the master at its respective unity to however you use the channel faders and control your sound system elsewhere.

Reticuli 0 votes
Actions pour les commentaires Permalien