Hopefully someone can give me a hand. The track decks and record in traktor 2.6.2 stop working after an hour of mixing. I noticed the load jumped into the red, then the decks, not the software, froze. I'm trying to figure out if it could be my latency, software configuration, or USB plug. The reason I say USB plug. I unplugged the B port on the 850 then plugged it back and everything started working again. My latency is 512 with 44100. I'm using 8 gb of Ram with a an A 8 processor in a 64 bit environment on windows 8. All my drivers, chipset and bios have been updated,. my computer has been optimized for traktor according to dub spot. What am I missing, besides a Mac? Will a 3.0 USB cable work and resolve this issue?
Il post è chiuso ai commenti.
@Andre > What decks were you using? Are you sure you have updated the firmware on both the players and the mixer? You can download it from here: http://pioneerdj.com/support
Have you tried adjusting the latency or did this only happen once? Can you reproduce the error?
Perhaps try upgrading to 2.6.3 - they note "various fixes and improvements" on the changelog, not sure if what you're describing is covered by that.
Assuming this issue has been resolved, given no response. If issues persists, please raise a new ticket.