U’King ZQ-B93B LED Colorful Beam Pinspot

Your lighting fixture has been added to the AtlaBase library (U King - LED Colorful Beam Pinspot). It will be reflected in the next rekordbox fixture library update. Please find the latest update of the fixture library here. 

On behalf of Pioneer DJ, 
AtlaBase Ltd 

Thank you. The global Rekordbox fixture was updated at 25. June and downloaded.
I found my new fixture, but always stay blank.
For Have colors, the 1st channel must be activated between 240-255
And
Channel 2 For Red
Channel 3 for Green
Channel 4 for Blue
Channel 5 for White

Best regards

Dear Sir,

Please update the fixture library to ver1122 or later from rekordbox lighting mode.

And you can see "LED Colorful Beam Pinspot" with search fixture.

Thanks,

Hello. Thank you for information.
I have the library version 1122.
The Group of Pinspots work fine with a DMX controler.
don’t work fine with Rekordbox.
Like explained
1st channel must be activated between 240-255
Channel 2 For Red
Channel 3 for Green
Channel 4 for Blue
Channel 5 for White

With rekordbox
Red, Green, Blue and white Spots stay activated => only a White Spot
whatever we select Red, Blue, Green or other colors selection on the Lighting panel.

Dear Sir,

Believe that ch1: dimmer / shutter, ch2, 3, 4 (R, G, B) works fine.
In rekordbox, ch5:White does not work because RGB has priority over White.

Thanks,

This fixture still does not work with latest fixture library 1341.

The result is that dimming and strobing work, but it is unable to change colors. I understand Rekordbox does not support the White channel, but this supposedly supports each of the R, G, and B channels and it does not.

Unrelated: I think it is also important to point out that only supporting RGB channels in and RGBW fixture leaves out part of the colorspace and could be supported by Rekordbox with no changes to the interface. I do hope the White channel will soon be supported by Rekordbox more broadly in a future release.

Per the above post from PatrickF: channel 1 on this fixture is multi-purpose for turning off, dimming, strobe, and independent RGBW control. It is not a simple dimmer.

0-8 is OFF
9-134 is for Dimming all RGBW channels simultaneously
------ higher values enable independent control of RGBW channels ------
135-239 is for Strobe level
240-255 is for ON

Dimming through Rekordbox would need to be supported directly on the RGB channels, rather than with the master dimmer, otherwise the colors cannot be controlled independently.

The partial workaround I found for this will enable RGB colors in Rekordbox, but no support for dimming. I created a DMX Direct Control that overrides the channel 1 (dimmer) from the scene, by holding it at 240. What I will probably do is use each scene's RGB value for dimming (toward 0). This is super awkward and time consuming to change all of the scenes I use.

Possibly the problem comes from the fact that there is a typo in the manual:

There are DMX overlaps. I have gone through some changes so that it follows your feedback. Changes will be reflected in the next rekordbox fixture library update (performed once a week on Wednesday or Thursday except for the national and company holidays). Please find the latest list of the library fixtures here (under Fixture library lists).

On behalf of Pioneer DJ,
AtlaBase Ltd

Thank you!