正式なコメント
Sorry, while you may be remapping the hardware, the software functions still remain as they are. You will note that the pads should remap the LEDs to match the chosen colours.
コメントアクション
投稿
フォローする
using pads for lighting functions
hi,
i put some lighting functions directly on the pads in the software.
Can I possibly change the label of the slicer pads in the surface?
The terms red, green, etc. would be better than 1,2,3. to understand.
投稿コメントは受け付けていません。
日付
投票
3件のコメント
I'm sorry, I'm not sure I understand what you're asking ... where are you wanting the label to appear?
コメントアクション
I would like to replace the existing caption (1-8) with texts like red, white, strobe if necessary.
コメントアクション