Have a feature request or suggestion? Post your idea here!

Publicação

2 seguidores Seguir
0
Avatar

DDJ SX2 Power on issue

I have just dusted off my DDJ SX2 after over a year in storage and have encountered an issue, the device would intermittently do the light up sequence and then shut down. At first I thought dead power supply but the fact I can enter update mode makes me uncertain. I tried flashing a newer firmware as mine was on 1.01 but made no difference. Suspecting water or moisture damage I decided to take the using alerts for further inspection, I could not see any issues so put the unit back together. I now get no light up sequence but can still enter update mode. So I have a few questions. Could a dodgy power supply cause intermittent issues. Is there a repair manual so can make sure I put the ribbon and plastic cables back correct. Any other tip / advice. Ordered a new power supply as a last resort.
Danny Jones Respondido

Comentário oficial

Avatar

Those manuals are intended only for authorized service technicians, and as such we are unable to provide assistance to end users regarding the disassembly, modification, or repair of hardware. Even if you're technically inclined, this is a legal liability issue so we're unable to provide support and must direct you to contact a Pioneer DJ authorized service centre in your region to have your hardware inspected and/or repaired. Sorry!

Pulse
Ações de comentário Permalink

Publicação fechada para comentários.

Data Votos

5 comentários

0
Avatar

Can you power it up using only USB power? It will work (XLR output will be disabled), but that could help diagnose if the board is problematic, or the power supply.

Pulse 0 votos
Ações de comentário Permalink
0
Avatar

I was not aware the SX2 could be powered via USB only, does the device do any light up sequence via USB power mode.?

I’m a little worried the device may be faulty now. If that turns out to be the case could you recommend any Pioneer repair services in or around the London Area.?

I thought only the older devices like the S1 and T1 could be USB powered.

Dan.

Danny Jones 0 votos
Ações de comentário Permalink
0
Avatar

Can I ask what this refers to, as found in the service manual.
For stabilization of power-supply start, the circuitry of the DSP PCB Assy was modified during production. The serial numbers of the DDJ-SX2 units with the modification are......

Mine is a model that does now have the modification.? Mine was released and sold before the fault was discovered and rectified.

Danny Jones 0 votos
Ações de comentário Permalink