While using the modulation on the XY pad with the flanger effect the XY pad would be stuck at the same value and I wasn't able to turn off the effects button.
Hope this gets fixed in the next firmware update. :)
Video demonstrating the problem:
@Raid Zero > The video makes it appear as if the touch-strip is detecting a continuous press 1/4 from the left side (shown where the value snaps to that point when you release the touch elsewhere on the strip).
I would direct you to contact Pioneer DJ technical support in your region to have the unit serviced.
Post ist für Kommentare geschlossen.
The Xpad with the Flanger effect only changes the values slightly and not by beat values, it is a fine adjustment and shown under the actual beat value.
Thanks for responding, but that doesn't solve the problem.
Hey Pulse, do you really think it's a problem with the hardware? I'm pretty hesitant to RMA w/ Pioneer again after my poor experience that last few times.
The problem went away after powering off the hardware and turning it back on.
It could be a sensitivity issue where the calibration is reset when power-cycling. Does it come back after a certain amount of time or only after use?