DDJ Ergo V Controller - Unable to use Product Correctly

Basically I've been using this new controller for approximately a month - everything was fine - traktor mappings worked, and all it's functionalities were okay.

All of a sudden recently, I switched on my Controller and after all the function and button LEDs blink as usual (startup routine of the controller) - the Loop Out Button on the Left Side (Deck C and a) Blinks Red and does not stop until I am forced to power off the controller - then again when I switch it back on the same thing occurs.

I would greatly appreciate immediate help as I really need to fix this fast,

Thanks and regards.

James CHIRCOP 19. Juni 2015 15:07

Post ist für Kommentare geschlossen.

Datum Stimmen

7 Kommentare

Not sure, I'm going to ask the engineers about that blinking LED.

Pulse 20. Juni 2015 23:30 0 Stimmen

Any updates to this?

Brendan-Mark Schembri 25. Juni 2015 05:08 0 Stimmen

Sorry, I've been busy with the changes to the site... but I do need some input...

When Loop-Out LED is flashing, USB communication error occurs. (USB microprocessor does not properly work.) First of all, please check if ERGO is correctly recognized when ERGO is connected to a computer.

For Windows
Please check the Pioneer version display utility from All the program -> Pioneer.
→ If ERGO is recognized, the version is shown.

For Mac
Select "About this Mac", then "System report". In the USB tab:
→If ERGO is recognized, the version is shown.

Please tell me if the version number is shown, if so, what is it?

Pulse 25. Juni 2015 18:55 0 Stimmen

Hello I have the Same Problem.
I Checked and it Showed 1.41

Simon Cadavid 5. September 2015 23:10 0 Stimmen

@Simon > Have you tried connecting it to another computer?

Pulse 6. September 2015 18:37 0 Stimmen

Hello I did but it remains the Same...

Simon Cadavid 6. September 2015 21:27 0 Stimmen

@Simon > As noted above, the loop-out blinking indicates a problem with the USB communication. If you've tried it with another computer / USB cable, and it doesn't respond properly, you may need to send the unit for servicing. Please contact Pioneer technical support in your region for assistance.

Pulse 9. September 2015 20:20 0 Stimmen