[CLOSED] HID does not work ? And a lot of latency in Timecode CDJ2000

Hi just bought serato.

Wen I set it up. Every time I wanna cue with the platter in scratch mode. The track runs out of position.

Check out my movie

https://www.facebook.com/photo.php?v=406457112700758

In HID mode CDJ can't start my tracks . I can se my tracks on my CDJ , I can select them but do not play.

Btw tell me if you can see my video then I load up a new one in Facebook with my settings and HID problem

DJ Meks 5. April 2012 19:10

Post ist für Kommentare geschlossen.

Datum Stimmen

7 Kommentare

in HID mode Serato has to be in INT mode, not ABS

BriChi 5. April 2012 19:12 0 Stimmen

Ah oky. HID works ! . Now my time code. Can you see the video?

DJ Meks 5. April 2012 19:16 0 Stimmen

it looks like it is moving after to stop, so drifting a little, go into the serato setup and lower the threshold a little, drop it like halfway or a little more then that to the right

BriChi 5. April 2012 19:19 0 Stimmen

Uhu I tried this. Is a lithe less drifting but still to much. Also when I put it more to the right the platter loses response :s

DJ Meks 5. April 2012 19:44 0 Stimmen

yeah not sure what to tell ya at this point, i know the drifting after stop has always been a problem but most people use REL mode with timecode so jumping the timecode up a couple of seconds avoids your issue. I couldn't imaging using ABS mode personally

BriChi 5. April 2012 20:21 0 Stimmen

Check out new video . You can see if I drastically increase the threshold the platter response drops drastically.

So serato does not respond to slow platter movement . with makes it also difficult setting a cue point. If I put it in the middle . It does not respond to slow movements and there is somme latency.

https://www.facebook.com/video/video.php?v=407045602641909&saved

Is this normal ?

DJ Meks 5. April 2012 20:22 0 Stimmen

yes

BriChi 5. April 2012 20:23 0 Stimmen