I've been noticing some issues with playback in standalone mode, where the waveform will act jumpy (similar to low refresh rate, as it jumps to the next beat rather than scrolls) as if the software is lagging. This might not be much of an issue but at times it will stop scrolling altogether, most notably near the end of a track (around where the timeline will blink as warning) and worsening, which can interfere with track staging and transitions.
Also, the master output trim cuts off quite early (midway past the 1st dot from -inf). probably not an issue but when it still has signal then goes into a hard cutoff rather than fading out smoothly almost ends up sounding like a failed pot (which shouldn't be the case, none of that traditional scratchy/crackling noise and it's only been in use for ~4 months).
I am using the most up to date firmware (1.0.1).
Given the description of the issues, I'd contact a Pioneer DJ authorized service centre in your region to have your hardware inspected and/or repaired, you'll be under warranty and they can diagnose the display problem as well.
Post ist für Kommentare geschlossen.