hello, I made the update 1.06 to 1.10
I encounter problem accurately in sync, especially using loops.
the 1.06 firmware worked much better.
Is it possible to return to a previous version?
thank you. . .
Post is closed for comments.
Only on special circumstances to they make a older f/w available to go back to Rakksy.. They normally don't recommend it. This f/w is having a lot of issues. But I think your issues are an on going issue that they haven't corrected yet. Unless your saying that it is even worse then before? Cause the sync and drifting loops have been an issue for a while. Hopefully we will here something soon. Try to hang in there.
thank you, Version 1.06 was more stable, everything was better calibrated. I really regret being passed to version 1.10.
and also switching the master was better now also on 1.06.
Frankly, it does pointless to buy nexus if sync is not the point.
I normally don't update my players for a few weeks after a update comes out. Cause there is ALWAYS issues. So I wait to see what is said about the update on the forum before I update.
right, because you completely.
this is why I'm not going to update 1.11
@rakksy > Do you use rekordbox? Are you on the latest version of rekordbox? Did you re-analyse all your tracks in 2.0.3?
@Gavin - I asked this question back when 2.0.3 was released but never got a response. I re-analyzed my tracks on 2.0.2 as prescribed by Pioneer in the release notes, but there was never any mention of needing to 're' re-analyze when 2.0.3 was released. Is there any benefit to doing so if you already analyzed in 2.0.2?
@Fox > No, 2.0.2 is the "first" version you need to re-analyse from - if you did it there you don't need to re-analyse again.
Awesome - thanks Gavin!
Gavin> Sorry for the delay, my tracks were already analyzed with version 2.0.2, I reanalyzed with version 2.0.3, but no change. Sync is not transmitted accurately since version 1.10 I never had this problem with version 1.06.
And another thing that bothers me: Both players are playing, when a player enters a loop enabled, the master automatically switches to the other deck, is this normal? ca also ca bothers me a lot, I was not on version 1.06.
@rakksy > Have you updated to 1.13 and has this resolved your issues?
@ Gavin> I have not yet been updated. I do not know if I should,
I feared to fall on other issues. . .
I know why I have this problem. Since the problem of changing master alone when playback is on an active loop.
Since I disabled the active loop, the master does not change, and my sync is more stable. But I do not think it's normal anyway.
Why have they not fixed this problem. However, many people complain about that.
Last week, I got an error code:
E-8302: CAN NOT PLAY TRACK (000A)
It was completely blocked, forced to restart the player.
Do you know what it could come?
@rakksy > There are several reasons an E8302 error could occur - it could be a corrupt file, a faulty USB stick, a loose Pro DJ Link connection etc... Did the error occur once only?
@rakksy > Any update?
@Gavin> No, not yet. I'm still using version 1.11
But it's always the same for me, it always shifts in a few seconds using loop.
Without using a loop, this is a little better, so I like that this time.
where I work as before, without master and out of sync.
Until version 1.06 it was very good.
I'm going on vacation for 4 weeks, I will update when I return.
I would keep you informed.