Hi,
Since one of the updates to rekordbox (I think) the curve no longer works on my RX. Watching the performance screen, if the crossfader is anywhere LH of centre rekordbox thinks its hard Left - vice versa.
Just upgraded again to new version, and have updated firmware now too.
In the settings of RB under controller, mixer crossfader curve greyed out (maybe just for internal mixer?)
I have replaced crossfader.
Just had to cancel a gig so any help appreciated!
The DDJ-RX has a hardware crossfade curve knob on the front panel, that's why you cannot adjust the curve within rekordbox.
Side note: There are ways to mix without a crossfader. You should not have had to cancel your gig due to this.
Post is closed for comments.
FYI it turns out this was a setting on the DDJ-RX that had reset after the update, the curve sensitivity had gone to 0!
And the set I had to perform... required the crossfader, no fader cut and shuts ;)
cheers anyway
HI I'm having the same problem, just got it updated and the crossfader still doesn't work
https://youtu.be/0v3482elELo her a video
I am having the same issue! Please help!!!!
Check your crossfader cut lag settings in Preferences.
I dont even have that menu! It stops at the output level! Ive uninstalled and restalled, got the latest update, got the latest firmware. Only had it a week!
Sorry, Jon. That menu is for the DDJ-RR. My mistake.
I am having the same issue! Please help!!!!
S.O.: Win 10 Home 1909
Rekordbox 5.8.1 rev.17519-16276-16283 x64
Firm Controller: 1.04
In program Rekorbox > preferences > controller > mixer > crossfader curve
This option is disabled when connect DDJ RX, but i connect XDJ-RX2 this option is enabled.
Midi settings is default > Crossfader Midi B61F > Type Knob/Slider (0h-3FFFh)
Reset controller not resolve
1. Disconnect the USB from the RX
2. Turn on the power of RX while pressing [SHIFT] button on the left deck and [DECK 1] button at the same time.
3. Wait for about 5 seconds.
4. Press the [SYNC] button on the both decks for 3 seconds
The crossfader response correctly when the controller not conected whit USB cable to the computer.
Help please, thanks!
