Hi dear,
I want to active or desactive stored loops during performance mode.
I've stored a loop into Hot Cue (https://forums.pioneerdj.com/hc/en-us/community/posts/210013503-Saving-loops-with-SX2-while-Performance-Mode-) and I want to active o desactive and when pointer of track is triggered then track will be in the loop.
I've been researching about it and i found this, the problem is in performance mode i can't see memory list (is there any way to set cue to memory list and see memory list in UI).
Thanks a lot.
Cheers
Post is closed for comments.
So it sounds like you should set the active loops in EXPORT mode first and then in PERFORMANCE mode just fire a loop when you want to vs waiting on the active loop. If I am not getting the question, please respond back and I'll get you a better answer...
Well, I'm used to Traktor o Serato where you can set saved loops, and active or desactive stored loops on the fly. The only way to do it is in export mode? Really?
I think is an important feature for DJ's: While we're mixing we try some loops, if the loop is ok then we saved, and of course we want to used in the future without to go track by track in EXPORT mode and set to memory cue....
Really there isn't an alternative mode?
Thanks
Cheers
You save a loop on the fly in performance mode the same way you save a Hot cue, so you don't need to do it in just Export mode.
I know i can save the loop, but I want to active or desactive saved loop later during PERFORMANCE MODE
But when I try to "active loop" using "shift + autoloop" RB shows a message: "There is no loop in memory list" (aprox) so if saved loop is not in the memory list i understand i can't active or desactive stored loops. Is it correct?
How can i add hot cue to memory list during the mix?
Thanks
Cheers
Hi dear,
Please I need a reply I've gigs next weekend and I'd solve this problem please.
Thanks.
Cheers
Hi, did you find an answer to this?
Hi, Unfortunelty nobody answer propertly the question, do you know how to solve this issue?
No, i would love to save"Activate" the Loops with my sx2. It seems you have to do it in the software not hardware.. I see you can do it on the RX, so I hope they change this in future update.