Went to the studios today who have a full NXS2 setup so wanted to try out linking my laptop to it (performance mode).
Followed the instructions in the manual (CDJ + DJM linked via LAN - then plugging my laptop into USB Port A on the DJM) - which gave me sound through the correct channels, but no control from either of the CDJ's.
I pressed the "Rekordbox" and "Link" buttons on both of them (CDJs) but no tracks where listed (just an empty grey page).
Is there a missing step in the document? It just says install the drivers (check) plug it all in and check the audio output settings are correct - it doesn't mention anything about CDJ controller input?
Is there a setting I need to change on the CDJ itself to start it working?
Plugging a USB stick into either of the CDJ's works fine - so it's confirmed the link is ok...
Edit: Just seen a post from Pulse saying this should work in Export mode too? I tried that as well, still no link...
If you're linking the players for EXPORT mode (and using the USB bridge to connect only one USB cable to your computer), you need to install the LINK EXPORT drivers - not the audio drivers.
Post is closed for comments.