use DDJ-XP2 as a control surface for Ableton
I Would like to use my XP2 as a control surface to Ableton Live 11.
The idea is to use this setup as a sampler. So, I would like to load my samples, kicks, drums etc. in Ableton as clips in session view.
Then from the XP2 I would like to be able to trigger the clips.
If I'm not mistaking the XP2 can also be used as a midi control device. So, would be useless to buy a Novation, Ableton Push 2 or Akai midi controller when I already have 32 pads on my XP2, right.
Is there a midi mapping available?
Thx for helping!
Iniciar sesión para dejar un comentario.
Kinda found an answer here: https://help.ableton.com/hc/en-us/articles/360000038859
So, I can launch my clips with the XP2, but there's a delay.
You can adjust the MIDI timing in the Ableton preferences.
The solution was setting the quantize to none