DDJ RX: Crossfader cut lag adjust HOW?

Sorry how can adjust Crossfader Cut Lag??? i have read from manual but i don't hunderstand, manual is not clear...who help and describe me how make this step by step?

Thenks for reply

Cisco Inter 24 de octubre de 2016 16:23 Respondida

Comentario oficial

Turn the unit off
Disconnect USB cable
Press and hold the SHIFT and PLAY buttons of the left deck and press the power button to turn the unit on to enter Utilities Mode
The cut lag value (0-52) is indicated by the number of LEDs that are lit on Channels 3 and 1. Channel 3 indicates the first digit, Channel 1 indicates the second digit. For example: In the image below channel 3 shows 3 LEDs and channel 1 shows 5 LEDs. This means the cut lag is set at 35.
Turning the rotary selector knob will adjust the cut lag up or down.

Mark Gallo 24 de octubre de 2016 21:24

La publicación no admite más comentarios.

Fecha Votos

9 comentarios

It's the knob on the far right front panel, turn that to adjust the curve.

Jay 24 de octubre de 2016 17:35 0 votos

sorry, this knobs don't work and crossfader it's too cut

or left, or right, or center don't have effect on crossfader

Cisco Inter 24 de octubre de 2016 20:44 0 votos

Hi Mark,

with this operation can i have a smooth crossfader curve?

How can i set for this?

Cisco Inter 25 de octubre de 2016 08:12 0 votos

There is a MAJOR difference between Cut Lag and Crossfader Curve. The procedure above changes the cut lag. To adjust the curve, use the knob on the front panel.

Mark Gallo 26 de octubre de 2016 02:23 0 votos

see my small video and listen Crossfader curve don't work, it's too HARD

https://www.facebook.com/100011307162963/videos/291079547945615/

don't work A channel 100 - 50 - 0

B channel 0 - 50 - 100

actually work (see image):

Cisco Inter 26 de octubre de 2016 08:01 0 votos

Then you need to adjust your cut lag to lower number.

Mark Gallo 3 de noviembre de 2016 20:14 0 votos

you and how can I do? if you saw the video I posted in the link you can understand and feel my problem

Cisco Inter 4 de noviembre de 2016 10:55 0 votos

I gave you the step by step instructions above.

Mark Gallo 11 de noviembre de 2016 19:04 0 votos