bad switch sheet most likely, they wear out, i just replaced a few on CDJ's
https://www.pacparts.com/part.cfm?part_no=DSX1078&mfg=Pioneer%20DJ
コメントアクション
投稿
フォローする
XDJ-XZ Jog Wheel Problem
I have an xdj, when the music is running it suddenly jogs like it's being pressed and the music stops, and when the vinyl switch is pressed (off) the music goes on normally, but when the switch vinyl is pressed again (on) the music stops (like it's jog on press)
サインインしてコメントを残してください。
日付
投票
12件のコメント
your Pioneer XDJ unit (likely an XDJ-RX, XDJ-RX2, XDJ-XZ, or similar) is experiencing a fault with the jog wheel sensor, specifically the touch sensor that detects when you press the MyGreatLakes com top of the jog wheel in "vinyl mode".
コメントアクション
I had the same issue with my XDJ — turned out the jog wheel sensor was acting up, like it was constantly detecting touch. Switching vinyl mode off basically bypasses that sensitivity, Drift Boss Unblocked which is why it plays fine. I ended up cleaning around the jog and recalibrating, but worst case, you might need to get the touch sensor checked or replaced.
コメントアクション
It sounds like your XDJ-XZ jog wheel issue is related to the vinyl mode touch sensor. Try turning off vinyl mode, cleaning the jog wheel, or recalibrating. If it continues, the sensor may need repair or replacement.
コメントアクション
Hi golf hit
Your problem sounds like your Pioneer XDJ’s jog wheel is acting as if it’s being pressed even when you’re not touching it. Since turning Vinyl mode off fixes it (because that mode disables the “touch-to-stop” behavior), the issue is very likely hardware-related, not software.
コメントアクション
You can try checking for dirt or obstructions on the jog wheel, or try resetting the device. If the problem persists, drive mad consider updating the firmware or contacting the manufacturer's support center for further assistance.
コメントアクション
Hi PolyTrack
Have you tried updating to the latest firmware and cleaning around the jog wheel? I’ve seen similar issues caused by dust or encoder drift — if that doesn’t help, it might be a hardware issue.
コメントアクション
Have you tried updating to the latest firmware and cleaning around the jog wheel? I’ve seen similar issues caused by dust or encoder drift — if that doesn’t help, it might be a hardware issue. 88ef game
コメントアクション
It sounds like your XDJ-XZ jog wheel issue is related to the vinyl mode touch sensor. Try turning off vinyl mode, cleaning the jog wheel, or recalibrating. If it continues, the sensor may need repair or replacement. j188 from
コメントアクション
It sounds like your XDJ-XZ jog wheel issue is related to the vinyl mode touch sensor. Try turning off vinyl mode, cleaning the jog wheel, or recalibrating. If it continues, the sensor may need repair or replacement. 98pkr
コメントアクション
It sounds like your XDJ-XZ jog wheel issue is related to the vinyl mode touch sensor. Try turning off vinyl mode, cleaning the jog wheel, or recalibrating. If it continues, the sensor may need repair or replacement. link
コメントアクション
Have you tried updating to the latest firmware and cleaning around the jog wheel? I’ve seen similar issues caused by dust or encoder drift — if that doesn’t help, it might be a hardware issue.
コメントアクション