DJM S11 - Smooth Echo Related

My S11 is not saving smooth echo settings parameters after a power cycle every time.

The mixer has the latest firmware installed.

Also the the latest version of Serato is installed on the laptop (Windows 10)

Any help would be appreciated.

Thanks

Ersal Ali 2020年12月18日 16:06

投稿コメントは受け付けていません。

日付投票

3件のコメント

If you're connected to the computer, it's possible the parameters are being overwritten by the utility app; does this only happen when it's connected?

Pulse 2020年12月18日 17:21 0 票

I just tried some further troubleshooting steps.. when i power up the mixer before launching Serato, the echo settings seem to be holding. If i start Serato first then start the mixer, the settings do not hold..

If i disconnect the usb cable to the mixer, the echo setting do not hold the parameters that were set previously.

Thanks

Ersal Ali 2020年12月18日 17:45 0 票

I had this same issue. I had to enable pc utility on the mixer. To do this go to the cog wheel > other settings > Pc utility > and set to on. After I turned that option on the settings saved.

Jeremy Mantele 2020年12月25日 02:35 0 票