DJM 900NXS2 phaser issue

So am I the only one that notices that the volume jumps down when I initiate the PHASER Effect?

Or is anybody else having this issue.

Note: I have the latest Firmware.

Michael Carlos Ramos 31 de Maio de 2016 19:14

Comentário oficial

That's because of how the effect operates and the intention to not have the audio clip due to an increased level during the effect.

Pulse 2 de Junho de 2016 22:29

Publicação fechada para comentários.

Data Votos

3 comentários

Yes, this might be by design as before updating firmware it was the same.
I think it was the same with my NXS1 mixer as well.

Bit crap really.

Shªun_N 1 de Junho de 2016 12:05 0 votos

Crap? That's a tad harsh. Would you rather have the club sound system output an excruciatingly loud pop/clip that would no doubt create an awkward moment for the crowd in addition to potential damaging the venue's audio system? That's what happens if the phasing effect were to begin modulation on a peak rather than a trough when being applied to a "loud" signal. Huge peaks in the frequency spectrum are never a good thing–nor is the resulting digital clipping.

lostnthesound 3 de Junho de 2016 19:41 0 votos